Typical induction heat seal defects TheSealCheck can detect:
- Shifted seals
- Overheated
- Underheated
- Missing seals
- Missing caps
- Folds off the landing
- Double seals
- Upside down seals
- Product in the seals
- Loose caps
- Cocked caps
- Channel leaks
Note: TheSealCheck: - Is a tool which will improve the quality of induction heat sealed
products going to your customers - Inspect and reject product at over 250ppm
- Has a saved images folder(in the C drive) which stores failed or all
images by date and time. - Can be used to monitor issues with the induction sealer or capper.
Example: if there are 5 fails/rejects in a row our controller can send a
24volt signal to a tower light or to shut the line down. Use the signal
as you wish.
Typical heat press heat seal defects TheSealCheck can detect:
- Shifted seals
- Overheated
- Underheated
- Missing seals
- Folds off the landing
- Double seals
- Product in the seals
- Channel leaks
Note: - TheSealCheck performance varies based on material of seal, landing of
container and maintenance of heat press head - TheSealCheck is a tool which will improve the quality of induction heat
sealed products.
Typical Linear heat seal defects TheSealCheck will detect:
- Skewed seals
- Product/foreign material in seals
- Missed seals
- Folded seals
- Short seals
- Low heat
- Uneven heat
Note: - TheSealCheck is a tool which will greatly improve the quality of your
heat-sealed products - TheSealCheck is also a diagnostic tool, which will provide real time
issues occurring on your lines.
